Scanner Configuration - Newland Scanners

Overview

This guide explains how to configure Newland scanners to work with the StoreFeeder WMS app. These instructions were followed on a Newland MT90 but may apply to other models.

Configuring the scanner

1. Open the Quick Settings app on the device.

   

   Alternatively, open the Settings app (cog icon), then go to Extend Settings > Scan Settings. Refer to the manufacturer's device manual for more details.

2. Change the following values:

   Output Mode:

   

   Broadcast-output Settings:

   • Broadcast action: com.sf.barcode.action

   

   Prefix & Suffix: both must be empty.

   

3. Back out of the screen to ensure the values are saved.

Completing the setup in the app

Open the StoreFeeder WMS app and go to Menu > Settings > On Device Scanner Configuration > I have updated the settings.

Tap I'm ready to scan and scan the barcode 12345678. If successful, a message appears at the bottom of the screen: "Scanner configured successfully".

To verify, go to Products from the slide-in menu and scan a product barcode. The app should populate the search field and perform the search without you needing to tap the screen or tap Search.

Troubleshooting

If a particular barcode type is not being scanned, go to Symbologies in the device Settings and ensure the relevant barcode type is enabled.